* Make a rack from where you can pull the wire from.
* Hit two 1/2 ich nails into frame one near wire starting point and another near ending point.
* Pass the wire through the frame holes.
* Then turn wire around it a couple of times
* hit with hammer on the nail.
* Pull from the free head of wire and with another hand tighten the wire and whole time pull with another hand.
* When wire sings, turn wire around another nail and hit on with hammer.
* Then put foundation into top bar grove.
* Foundation rests on the wires.
* Between lower bar and foundation it must be 10 millimeter distance. Otherwise foundation will curve when it enlarge in warm hive.
* Give elctronic circuit through the wire with A or B
A) alternative : put 1000 W resistance inside circuit. Something heating appliance etc.
B) use car akku loader and give cirguit from conducting wires.