Welcome, Guest

Author Topic: honey extractor shaft removal?  (Read 750 times)

Offline the-ecohouse.com

  • House Bee
  • **
  • Posts: 263
    • the-ecohouse.com
honey extractor shaft removal?
« on: June 29, 2012, 08:45:57 AM »

Hi Guys i'm trying to remove this shaft from my extractor motor any ideas on how to do that?






Offline Joe D

  • Super Bee
  • *****
  • Posts: 2048
  • Gender: Male
Re: honey extractor shaft removal?
« Reply #1 on: June 29, 2012, 09:39:53 AM »

Eco is there a set screw in the side of the coupling, in the small whole in the second picture, and some times there is 2 set screws one on top of the other.  If you have taken it out you may have to knock or press the coupling off.  Good luck.



Joe

Offline the-ecohouse.com

  • House Bee
  • **
  • Posts: 263
    • the-ecohouse.com
Re: honey extractor shaft removal?
« Reply #2 on: June 29, 2012, 09:48:20 AM »
nice i'll give that a go, thought it might be a split pin cheers

Offline Beeboy01

  • House Bee
  • **
  • Posts: 140
  • Gender: Male
  • Oh Look A Honey Bee !!!
Re: honey extractor shaft removal?
« Reply #3 on: June 29, 2012, 06:27:08 PM »
If it was a split pin the hole would go all the way through the shaft so it could be pushed out by a punch. Once you get it apart you might need to file down the spot where the setscrew dug into the shaft, It will make the reassembly a whole lot easier.