Need Bees Removed?
International
Beekeeping Forums
July 30, 2014, 01:31:01 PM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: ATTENTION ALL NEW MEMBERS
PLEASE READ THIS OR YOUR ACCOUNT MAY BE DELETED - CLICK HERE
 
   Home   Help Search Calendar bee removal Login Register Chat  

Pages: [1]   Go Down
  Print  
Author Topic: Simple to make Top Bar Hive Feeder  (Read 4982 times)
showme714
House Bee
**
Offline Offline

Gender: Male
Posts: 70


Location: Lithonia, Ga.


« on: March 10, 2011, 10:11:55 PM »

I wanted to share with everyone a simple TBH feeder I made. It is easy to clean and only takes up four bars of space. It can be used to feed syrup or fondant. I hope this helps someone and inspire others to make an even better one.



Uploaded with ImageShack.us

To start I bought a 16-cup storage dispenser for cereal from Walmart and cut off the top 3 1/2 inches. Cost was around $3.50. The purpose was to have a feeder with as few parts and seams that would need sealing. I didn't want to worry about leaking and it needed to be easy to remove and clean.



Uploaded with ImageShack.us

I measured and drew a template of the container on a follower board. I used three pieces of scrap wood to serve as a frame holder for the container. They are glued and screwed in place.



Uploaded with ImageShack.us

I then cut out a section of the container to serve as an entrance to the food source. This plastic was difficult to cut with a utility knife. It is also easy to crack in the wrong place with too much force. I ended up using a Dremel tool with a cutting wheel which made it easy and accurate.



Uploaded with ImageShack.us

Next I added a fourth piece of scrap wood cut to fit to hold the container in place. It also acts as a platform for the bees.



Uploaded with ImageShack.us

I then made a floating platform for the bees cut to fit and not allow the bees to drown. It has five stations drilled halfway through with a hole in the middle for the bees to feed. It will be coated in beeswax to make it waterproof.



Uploaded with ImageShack.us

Finally I made a top board for it. It is 17 inches long a 4 bars wide. Because of the pieces of wood that make the sides of the frame, this top board is not necessary as the feeder can just sit in the feeder and you could use four regular bars to cover it. However, this top board cover allows for easy refilling without disturbing the bees. It also has a cover to prevent unwanted guests from getting in.



Uploaded with ImageShack.us

That's all there is to it! Here's what it looks like in the hive.



Uploaded with ImageShack.us
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Beemaster's Beekeeping Ring
Previous | Home | Join | Random | Next
Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines | Sitemap Valid XHTML 1.0! Valid CSS!
Page created in 0.24 seconds with 21 queries.

Google visited last this page Today at 03:26:02 AM
anything