I had started a post under "Comb", but after reading many post on what I wanted to do I changed my mind and tried to copy a couple other post on making a Kenyan Top Bar Hive Feeder. I used 1 inch cedar 3 3/4 inches wide and 17 1/4 long to fit my hive then I used the same material only 3 1/2 wide for the sides and bottom, I cut them at 22 1/2 miter to fit my hive, glued with Titty bond 3 and screwed all the boards together, Then I took Plexiglas and cut it to match my frame and one side I cut a slot 5 inches wide and 1/2 inch deep at the center top, after a couple tries I used the correct material, liquid nails, clear and glued the Plexi to the frame. I finished it off by melting some paraffin wax and pouring it inside turning the feeder in different directions so all the edges got covered and sealed. I took some of my bottom screen #8 wire and cut it so it would go to the bottom of the feeder and hang out the slot I cut this way the girls have a ladder to climb on. The picture on on my Photobucket ->
http://s1090.photobucket.com/albums/i373/MRTMEAIt will hold 1 gallon of sugar water
