This turned out so efficient. I have a 12volt model with 25ft of lamp cord and battery clamps. I got 6 digital timers w/ memory for 1.00ea at the dollar store. One blue one preset for 2 min. and 5 red preset for 10 min. I pull up, pop the hood, set the blue timer on the battery and a red timer on each of the first 6 hives. Out of the back I pull out my med size cooler/ mite treatment kit. First I pull out the burner, place it on the ground in front of the first colony along with the tub of acid w/ measuring spoon and a damp rag. I run the cord to the truck battery and clamp one side on. Back to the cooler i grab a roll of duct tape and 6 strips of carpet pad 2" X 18". Place 1 pad in front of each of the first 6
Fill the burner and slide it in. Push carpet pad in to plug bottom enterence. Duct tape top enterance. Back to truck Hook up battery and start blue timer. At 2 minutes the timer beeps. disconnect battery and start red 10min timer on top of 1st colony. Slide out burn, replug with carpet pad and cool with a damp rag. Move to 2nd colony and start the whole proccess again. When I get to the 6th colony the 1st is beeping that the 10 min seal up time is up.
I can do 1/2 doz in less the 20 minutes