Welcome, Guest

Author Topic: extractor stand  (Read 1049 times)

Offline Ross

  • Field Bee
  • ***
  • Posts: 512
    • http://www.myoldtools.com
extractor stand
« on: June 14, 2008, 02:20:18 PM »
Somebody here or on another board ask for an extractor stand.  I did this one in about 20 minutes.  Rip to width on the table saw (so a 5 gallon bucket will fit under your spout).  Cut two notches with a saber saw, jig saw, bandsaw, handsaw, etc.  Assemble.  Nock down when done extracting and store flat.  The holes are to strap down the extractor with ratchet straps.

Those who don't read good books have no advantage over those who can't---Mark Twain